Used Nissei Equipment for Sale

Nissei Plastic Industrial Co., Ltd. was founded in October 1947 by Katashi Aoki in Sakaki-machi, Nagano Prefecture, Japan. Aoki began by processing acrylic materials into everyday consumer goods, then developed his own injection molding machine in 1957 to improve product quality — a pivot that defined the company's entire future. From that single machine, Nissei grew into one of Japan's most recognized injection molding equipment makers, eventually listing on the Tokyo Stock Exchange and exporting machines to more than 80 countries.

Nissei's horizontal injection molding machines are the heart of its product lineup and the machines most commonly found on the used market. The FNX series — including the FNX-III generation — is a horizontal hybrid design that pairs Nissei's proprietary X-Pump servo-hydraulic system with direct-pressure clamping, delivering energy savings close to all-electric levels while retaining the high-load injection capability of hydraulic machines. The larger FVX and FVX-III series extend the same hybrid platform to heavier tonnages favored in automotive work. For buyers who prefer fully electric operation, the NEX series — spanning NEX-III, NEX-IV, and NEX-V generations — offers all-servo horizontal machines prized for shot-to-shot repeatability and low energy consumption. All current series use Nissei's TACT controller, which simplifies setup and supports quality-management data logging.

Nissei horizontal injection molding machines serve a broad range of end markets. Medical device manufacturers rely on the NEX all-electric series for the cleanliness and repeatability required in syringe barrels, connectors, and diagnostic components. Automotive suppliers use the FNX and FVX hybrid series for interior trim, under-hood parts, and structural components where high clamping force and cycle consistency are critical. Consumer electronics, packaging, and general industrial molders also run Nissei equipment, drawn by the machines' ability to handle engineering resins and tight-tolerance tooling across a wide shot-size range.

Used Nissei horizontal injection molding machines attract strong buyer interest for several practical reasons. The machines are built to long service lives, and even older FNX and NEX models routinely accumulate tens of thousands of operating hours while maintaining dimensional accuracy. Nissei America's parts center in San Antonio, Texas stocks replacement components, making service straightforward for North American operators. The X-Pump hybrid system's energy efficiency lowers operating costs compared with conventional hydraulic presses, which helps justify acquisition even at used-market prices. Taken together, durability, parts support, and lower running costs give Nissei equipment solid resale value across successive ownership cycles.

Meadoworks is your trusted source for used Nissei equipment. As third-generation industrial equipment dealers and AMEA-certified appraisers with over 50 years of experience, we offer quality-inspected Nissei machines at competitive prices. Browse the 11 used Nissei machines listed above, or call 800-323-0307 for equipment not yet listed.

Every machine includes detailed specifications and high-resolution photos, and inspection visits are available for most equipment. We ship worldwide with experienced rigging partners and offer financing for qualified buyers. Have Nissei equipment to sell? Get a free valuation or contact our team.